The browser you are using is not supported by this website. All versions of Internet Explorer are no longer supported, either by us or Microsoft (read more here: https://www.microsoft.com/en-us/microsoft-365/windows/end-of-ie-support).

Please use a modern browser to fully experience our website, such as the newest versions of Edge, Chrome, Firefox or Safari etc.

Methodology for Sampling and Characterizing Internally Mixed Soot-Tar Particles Suspended in the Product Gas from Biomass Gasification Processes

På svenska

Author

Summary, in English

When biomass is used to produce fuels and green products by thermochemical conversion, the ability to handle or remove the fine particle phase in the product gas is crucial. The product gas from biomass gasification contains relatively volatile organic compounds (“tar”) condensed on nonvolatile cores of, for example, aggregated soot particles and char. The problems are, for example, that particles will poison catalysts used for upgrading of the gas and loss of thermal energy occurs when carbonaceous particles are being formed. The aim of the work is to design and use novel methodologies to characterize the particles in the product gas stream. A methodology has been developed to sample and characterize fine particles by a sampling probe connected to either a denuder or a packed bed device. The system was designed to avoid condensation of organic compounds when diluting the sample and decreasing the temperature. A flame soot generator connected to a condensation−evaporation unit was used to produce internally mixed model particles, i.e., particles consisting of a core of soot with an outer layer of condensed volatile compounds. A scanning mobility particle sizer (SMPS) and a differential mobility analyzer followed by an aerosol particle mass analyzer (APM) were used to characterize the particles. Because of the agglomerated structure of soot, the SMPS system was not adequate to fully characterize the mass of volatiles condensed onto the soot core, and therefore the DMA-heater-APM technique was used to determine the mass fraction of the condensed phase on the soot particles. The two different configurations were studied, and the sampling system was shown to work at a high load of organic mass. In both cases, the organic removal efficiency was >99.5%. Minor condensation of organics on the sampled soot was found for the denuder but not the packed bed. On the other hand, the particle losses were substantially higher for the packed bed compared to the denuder. The results showed that the tested sampling methodology can be used to get sufficient characterization of particles in the product gas and to evaluate the performance of biomass product gas cleaning systems at high temperature.

Publishing year

2011

Language

English

Pages

1751-1758

Publication/Series

Energy & Fuels

Volume

25

Issue

4

Document type

Journal article

Publisher

The American Chemical Society (ACS)

Topic

  • Production Engineering, Human Work Science and Ergonomics

Keywords

  • soot particles
  • tar
  • high temperature sampling
  • gasification
  • gas cleaning system
  • product gas
  • APM
  • aerosol

Status

Published

ISBN/ISSN/Other

  • ISSN: 0887-0624