The browser you are using is not supported by this website. All versions of Internet Explorer are no longer supported, either by us or Microsoft (read more here: https://www.microsoft.com/en-us/microsoft-365/windows/end-of-ie-support).

Please use a modern browser to fully experience our website, such as the newest versions of Edge, Chrome, Firefox or Safari etc.

A 28 GHz SiGe PLL for an 81-86 GHz E-band beam steering transmitter plus an I/Q phase imbalance detection and compensation circuit

På svenska

Author

Summary, in English

This paper presents two circuits, a complete 1.5 V 28 GHz SiGe beam steering PLL and a standalone 28 GHz QVCO with I/Q phase imbalance detection and compensation. The circuits were designed in a SiGe process with f T = 200 GHz. The PLL is intended to be used for beam steering in an 81–86 GHz E-band transmitter. Phase control is implemented by DC current injection at the output of a Gilbert architecture phase detector showing a simulated phase control sensitivity of 1.2°/µA over a range close to 180°. The simulations use layout parasitics for the QVCO, frequency divider, and phase detector, and an electromagnetic model for the QVCO inductors. The divider is implemented with four cascaded divide-by-two current-mode-logic blocks for a reference frequency of 1.75 GHz. For closed loop simulations of PLL noise and stability, the QVCO is represented with a behavior model with added phase noise. This simulation technique enabled faster simulation time of the PLL. The PLL in band phase noise at 1 MHz offset equals −115 dBc/Hz. Excluding output buffers, the entire PLL consumes 52 mW plus a minimum 7 mW from a variable high voltage supply required to extend the PLL locking range. The measured phase noise of the standalone QVCO equals −100 dBc/Hz at 1 MHz offset. Since E-band radio links utilize higher order QAM modulation, the bit-error rate is sensitive to I/Q phase error. In the measured standalone QVCO with I/Q phase imbalance detection and compensation, the error is detected in two cross coupled active mixers that have an output DC level proportional to the phase error. The error can then be eliminated adjusting the bias of four varactors connected to the QVCO outputs. The current consumption of the chip equals 14 mA from a 1.5 V supply and 57 mA from a 2.5 V supply dedicated to the detector and 28 GHz output measurement buffers

Publishing year

2015

Language

English

Pages

383-398

Publication/Series

Analog Integrated Circuits and Signal Processing

Volume

84

Issue

3

Document type

Journal article

Publisher

Springer

Topic

  • Electrical Engineering, Electronic Engineering, Information Engineering

Status

Published

Research group

  • Analog RF

ISBN/ISSN/Other

  • ISSN: 0925-1030