The browser you are using is not supported by this website. All versions of Internet Explorer are no longer supported, either by us or Microsoft (read more here: https://www.microsoft.com/en-us/microsoft-365/windows/end-of-ie-support).

Please use a modern browser to fully experience our website, such as the newest versions of Edge, Chrome, Firefox or Safari etc.

Investigation of combustion enhancement by ozone additive in CH(4)/air flames using direct laminar burning velocity measurements and kinetic simulations

Author

Summary, in English

The effect of ozone additive on the enhancement of the burning velocity for premixed methane-air flames is investigated by both experimental measurements and kinetic simulations. Laminar burning velocities with and without O(3) were directly measured using the Heat Flux method. The O(3) molecules were introduced into the system by a dielectric-barrier-discharge ozone generator installed in the O(2) gas line, which provided prompt control of on/off of the O(3) feed into the system, enabling a precise comparison of the measured burning velocity with and without ozone additives. Noticeable burning velocity enhancement was observed at off-stoichiometric conditions rather than stoichiometric conditions. With 3730 ppm O(3) additive in the oxidizer, experimental data shows similar to 8% burning velocity increase in fuel-rich mixtures and similar to 3.5% burning velocity increase for the stoichiometric mixture. With 7000 ppm ozone additive in the oxidizer, maximum similar to 16% burning velocity increase was observed at fuel-lean conditions while similar to 9.0% was found at fuel-rich conditions. An O(3) kinetic mechanism involving 16 elementary reactions together with the GRI-Mech 3.0 was composed and validated through CHEMKIN calculations, which gives good predictions of the burning velocities with and without O(3) additives. Extra O radicals contributed by O(3) molecules in the pre-heat zone initiate and accelerate the chain-branching reactions and consequently increase the burning velocity. (C) 2011 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Department/s

Publishing year

2012

Language

English

Pages

120-129

Publication/Series

Combustion and Flame

Volume

159

Issue

1

Document type

Journal article

Publisher

Elsevier

Topic

  • Atom and Molecular Physics and Optics

Keywords

  • Ozone
  • Laminar burning velocity
  • Combustion enhancement
  • Heat Flux
  • method
  • Methane flame

Status

Published

ISBN/ISSN/Other

  • ISSN: 0010-2180